Field-controls Gas Spillage Sensing Kit GSK-160A User Manual download pdf

2630 Airport Road · Kinston, NC 28504

Phone: 252-522-3031· Fax: 252-522-0214

www.fieldcontrols.com

GAS SPILLAGE SENSING KIT

Model: GSK-160A

(with automatic reset)

Installation of a spillage SAFETY Switch is recommended for

LP and Natural gas fired systems with gas barometric draft

controls. This device is intended for installation on a

double-acting barometric draft control (such as the Field

Controls model MG-1) that is installed in the venting

system of an 80+ efficiency rated, fan-assisted gas-fired

appliance. It is designed to detect flue gas spillage caused by a

blocked flue system and/or inadequate draft. This device MUST

be installed by a qualified installer in accordance with the

manufacturer's installation instructions. Wiring MUST be in

accordance with the National Electrical Code and applicable

local codes.

Before and after adding this safety control on existing

appliances, an installation inspection in accordance with the

National Fuel Gas Code 54, Z223.1 Appendix H should be

performed and a combustion analysis is recommended to

determine the operating condition of the appliance.

CAUTION: Disconnect Electrical Power When Wiring Spillage

Switch

1 2 3 4

2630 Airport Road · Kinston, NC 28504 Phone: 252-522-3031· Fax: 252-522-0214 www.fieldcontrols.com GAS SPILLAGE SENSING KIT Model: GSK-160A (with aut

Page 2Figure 3OPERATION: The GSK-160A is a normally closed single-pole, single throw (SPST) thermally-activated switch that is intended to be wired i

Page 3WIRING: CAUTION: When wiring the spillage switch into the burner control circuit route the wiring and secure away from any hot surface. Shut of

Page 4 P/N 46561800 07/08

No comments

Field-controls Gas Spillage Sensing Kit GSK-160A User Manual